Accessories a. Insure Power Unit has a designated ground wire 4.) Operate wireless unit to insure Unit is operating properly Function 1.) This device is activated by pushing either button 1 or 2 to power the unit. 2.) 20 Minute shut off (receiver shuts down after being idle for 20 minutes) a. Press both buttons 1 & 2 for 10- 20 seconds to end Shutdown Mode b. When in Shutdown Mode, Wireless receiver is the only item shutdown, Out Put 2 is still active 3.) Operating Frequency: 315MHz How to operate the Remote Learning mode 1.) Remove wired hand control to prevent accidental operation. 2.) Disconnect Positive (Red) & Negative (Black) Ring Terminals 3.) Place Programming Sleeve (Shunt) on Pin 1 and Pin 2, to activate Programming Mode. Fig. 2,3,4 4.) Reconnect Positive (Red) & Negative (Black) Ring Terminals (Receiver will click) 5.) Press either button 1 or 2 (receiver will click 2 to 9 times depending on how long you hold the button down) 6.) Replace program pin on the receiver to end Learning Mode. (When in learning mode Remote Unit must be operated within 3-5 seconds to learn new code. Otherwise the device will jump back and resume previous frequency.) Unit may not operate below 11 Volts. ONBOARD BATTERY CHARGER & TESTER 1. SPECIFICATIONS ITEM DESCRIPTION Input AC 120V, 60Hz, 0.4amp Output DC 12V, 1.5amp Battery Cables 24 inches, 18AWG Lead Wire 3-Prong Plug Features LED Self-resetting circuit breaker 142 2. OPERATION 1) Connect the positive (red) cable to the positive terminal of the battery. Connect the negative (Black) cable to the negative terminal of the battery. 2) Connect the power outlet (110VAC/60Hz) to the 3-Prong plug of the charger. 3) The LED on the battery charger will indicate the status of the charger. 4) The LED on the battery tester will indicate the statue of the battery and alternator/charging system. 5) To test a battery, the vehicle’s engine, lighting, and accessories must be off. 6) To test an alternator/charging system, the engine must be running at 2,000 RMP minimum, the lights and accessories must be turned off and the unit must be unplugged from the AC power. 7) Then simply push the “PUSH” button to get your test results. 3. LED Indication
20558CB
To see the actual publication please follow the link above