Page 142

20558CB

Accessories KTI TRIPLE ACTING POWER UNIT (POWER UP/POWER DOWN/GRAVITY DOWN) diagram A-1 diagram A-2 diagram A-3 diagram A-4 When stowing your three-piece remote pendant, it is recommended that you store the remote switch box portion in your vehicle. This will help preserve the new condition of the remote control and prevent theft. Installation 1. Install 9/16-18 SAE ORB, SAE #6, hydraulic fittings into ports “A” and “B”. Torque your hydraulic fittings to 18 ft-lb. 2. Remove the Three-button pendant from the power unit at the quick disconnect. 3. Mount the Power Unit using two, 3/8-16 UNC mounting bolts (diagram A-3) 4. Remove the Filler/Breather Cap and fill the reservoir with hydraulic oil to the Full line on Reservoir Label. Approx. one (1) inch from the top (See fluid recommendations). 5. Replace the filler/breather cap. 6. Connect Hydraulic Lines to ports “A” (TOP) & “B” (BOTTOM). a) Check the torque specifications for the hose fittings. b) Connect the Base of the Cylinder to port “A” (TOP). c) Connect the Rod End of the Cylinder to port “B” (BOTTOM). 7. Connect the battery Ground cable to the Ground terminal of the DC Motor (diagram A-3) 8. Connect the Positive cable from the battery to the start solenoid (diagram A-4). (See Battery Gauge / Cable length table on pg.2 to help you select the proper gauge and length of cables for your unit.) 9. Holding the bottom nut with a wrench, torque the battery connections to 3 lb-ft. 10. Reconnect the three-button remote pendant at the quick disconnect. 11. Operate the power unit while also keeping an eye on the fluid level in the reservoir. a. Insure that the fluid level doesn’t go lower than ½ full during the initial start up. b. When the cylinder is fully extended, the reservoir should be about ½ full. 138


20558CB
To see the actual publication please follow the link above